Valcom's networked Audio Ports enable voice access to one-way paging over an IP-based network. This allows page zone extension anywhere on the network.

The Audio Port enables voice access to a single zone of one-way paging over an IP network, allowing page zones to be extended anywhere network connectivity is available. The Audio Port can be programmed as a SIP (Session Initiation Protocol) device for connectivity to virtually any Voice over IP (VoIP) telephone system.

Valcom VIP-804B Quad Enhanced Network Audio Port.

Features:

• 4 Audio Output and Input
• 4 Form A Relays
• 4 Contact Closure Inputs
• 4 SIP identities for registering to a VoIP telephone system
• RJ-45 jack for network connection
• Front panel activity LED
• Provides audio for up to 40 Valcom one-way amplified speaker assemblies
• AUX audio input via RCA jack
• Contact closure or VOX operation of audio input
• Removable screw terminal connectors provided for audio and relay interface
• AUX input music mutes during page
• Output control contact closure provided during paging output
• Compatible with 25 or 70 Volt amplifiers
• 2.5mm jack for optional DC power
• Power over Ethernet (PoE) 802.3af compatible
• No Server Required
• 1 to 11 Digit Dial Plans
• Easy Windows Based Setup
• AUX Audio input

Specifications:

• VoIP Remote handset paging system access to networked VIP-800 audio adapters
• Point to point or multi-point communication to other telephones and PagePac station doorphone call in stations
• Ringdown circuit
• Information phones - using ringdown with 2500 set

Input:

• Analog device line interface-
• 600 Ohm Input Impedance
• VOX and Contact closure input

Output:

• Analog output interface
• Less than 50 Ohms output impedance
• Frequency Response: 200 Hz – 3400 Hz
• Relay closure available

Control Unit Power Requirements: +40 Valcom Power Unit

Learn More

Installation

Specs.

Do you need a Cable Run? Ceiling Speakers & Horns? CommGear sells them. Install and service at an additional charge.

Replaces VIP-804 & VIP-804A.